HIGH PERFORMANCE CERAMIC COATING
Fluna GunCoating is a high-quality ceramic coating for all types of firearms and knives.
Despite its extremely lubricating properties, Fluna GunCoating is residue-free, forms an invisible, dry film on the weapon, and increases the sliding properties of moving parts on the weapon.
Loud, metallic sounds of rubbing parts — such as latches on latches on bolt guns — are significantly reduced.
Fluna GunCoating forms a firm adhesion with the surface, does not run off and thus protects the weapon against corrosion for a long time.
Fluna GunCoating can be applied to all surfaces such as steel, plastic, painted wooden parts, gold and silver decorations, colored pavement, cast iron and rubber.
Fluna GunCoating evens out microscopic cracks and grooves and permanently smoothes the treated surfaces. Wear and tear is kept to a minimum and the shooting performance of the weapon is increased.
Fluna GunCoating works from the first treatment – even with older pistols!
Attributes
- Suitable for knives and all types of firearms
- Can be applied to any surface
- Transparent, residue-free, non-greasy coating
- Very good sliding properties, long-lasting effect
- Salt and freshwater resistant, economical in use
- High temperature resistance from -40°C to +750°C
- Does not shear, does not stick, is colorless and odorless
- Cleaning the weapon is made easier
INSTRUCTIONS
Fluna GunCoating is always applied to the cleaned weapon. Metal parts must be degreased before use so that the ceramic particles can adhere directly to the metal. Use Fluna Gun Degreaser for degreasing. Fluna GunCoating is thinly dripped on the surface and then spread out with a lint-free cloth so that a thin, moist film is deposited on the surface. Fluna GunCoating then dries automatically. The coating is dry after approx. 30 minutes at room temperature and fully cured after approx. 2 hours. When using the vessel, make sure that the vessel is thoroughly cleaned beforehand. Fluna GunCoating is then applied thinly with cotton wool or a felt plug. The spray can is recommended for care of large surfaces. The liquid product in the dropper bottle should be used for coating small parts and adjusting the deductions.
